Pentair Sta-Rite PL Series Thermoplastic Convertible Deep Well Jet Pumps

Main Content Starts Here

Pentair Sta-Rite PL Series Thermoplastic Convertible Deep Well Jet Pumps

The performance-proven PL Series is constructed to be lightweight and extremely resistant to sand and abrasive wear, it performs best on all deep well installations.

Key Features

  • Superior Rustproof Construction - Pump body is Dura-Glas fiberglass reinforced thermoplastic - lightweight, rustproof and exceptionally strong. All components in contact with water are resistant to the corrosive and abrasive forces found in the most aggressive water conditions.
  • Heavy-duty Motor - Dustproof canopy completely encloses electrical components and provides dust, dirt and insect protection. Ventilating air cannot contaminate vital switching components. Permanently lubricated, heavy-duty ball bearings ensure smooth, quiet operation and extended motor life.
  • Precision Diffuser - Multi-port, reinforced polypropylene design primes faster and handles more air.
  • Precision Molded Impeller - Precision molded Noryl® gives perfect balance and ultra-smoothness for highest performance and efficiency.

Warranty

1 year limited warranty

Find out where to purchase online or in a retail location near you.

Performance Curve

 

Specifications

Item #Horsepower
PLC1/2
PLD3/4
PLE1
PLF1-1/2
Item #Horsepower
PLC1/2
PLD3/4
PLE1
PLF1-1/2

BODY CONSTRUCTION:  Thermoplastic
MAXIMUM CAPACITY:  26.3 GPM (Model PLE with Shallow Well Setup)
FLOW at 10' LIFT and 40 PSI:  13.8 GPM (Model PLD Shallow Well Setup)
MAX LIFT:  25' w/ Shallow Well jet Kit / 60' w/ Deep Well Jet Kit
MAX SHUT-OFF PRESSURE:  72 PSI (model PLC in shallow well config)
MAXIMUM TOTAL PRESSURE (Inlet + Pump Pressure):  PLC: 72 PSI / PLD:62 PSI / PLE: 62 PSI / PLF: 64 PSI
PRESSURE SWITCH SETTING:  30-50 PSI
SUCTION SIZE:  1-1/4" NPR
DRIVE SIZE:  1" NPT (suction-over-drive)
DISCHARGE SIZE:  1" NPT
AMP DRAW (full load):  6.1 amps on 230v / 12.2 amps on 115v
VOLTAGE:  115v/230v AC, 60 Hz, 1-phase
MAXIMUM LIQUID TEMPERATURE:  140 F (60 C)

Noryl® is a registered trademark of SABIC Innovative Plastics IP BV

Back to top of page