Main Content Starts Here

Cast Iron Submersible Effluent Pump - ME7 Series

  • Bearing and Mechanical Seal – Permanently lubricated for long life.
  • Overload Protection – Built-in thermal overload with automatic reset.
  • Cord Design – Prevents oil loss from and moisture protection for motor.
  • Serviceability – Heavy-duty lift-out ring, field serviceable.
  • Solids Handling – 3/4” spherical capability.
  • Stainless Steel Hardware – Allows for easy disassembly after extended service.
  • Controls – Standard controls available for automatic operation.
  • Float – Mechanical (non mercury).

 

Applications:  Effluent and Wastewater Removal, Sump Drainage, Dewatering, Flood Control

Capacities:  110 GPM 416 LPM

Shut-off head:  58’ 17.7 m

Operation: Tethered:  On: 18” 459.7 mm | Off: 9” 231.1 mm

Solids handling:  3/4” 19 mm

Intermittent liquid temp:  130°F 54.4°C

Motor:  1/2 HP, 3450 RPM, 115 Volt or 230 Volt, single-phase, 60 Hz. Oil-filled. Built-in thermal overload protection with automatic reset and permanent split capacitor.

Acceptable pH range:  6-9

Shaft seal:  Type 6A or equal, Buna-N elastomers, silicon carbide sealing faces, stainless steel metal parts

Motor housing:  Cast iron

Volute case:  Cast iron

Impeller:  Cast iron Vortex

Power cord:  20’ oil and water resistant 16-3 SJTW-A/SJTW with integrally grounded three-prong plug.

Discharge, NPT:  2” (50.8 mm)

 

OWNER'S MANUAL: ME7, M37, MWS37, MWS9, MWS39
DOWNLOAD MANUAL

SELL SHEET: ME7
DOWNLOAD SHEET