Main Content Starts Here

7-1/2 HP Centrifugal Grinder Vortex Impeller - WG75HH, WGX75HH

Capacities To 150 gpm (568 lpm)

Pressure To 257 ft. of head (78 m)

Liquids Handling
-- Domestic raw sewage

Intermittent Liquid Temp. up to 140°F (up to 60°C)

Winding Insulation Temp. (Class H) 356°F (180°C)

Motor Electrical Data
-- 3450 RPM: 7½, 10 and 15 HP 200/230/460/575 volts 3 phase, 60 Hz

Std. Third Party Approvals CSA

Optional Approvals FM Class 1, Groups C & D (WGX750HH only)

Acceptable pH Range 6 – 9

Specific Gravity .9 – 1.1

Viscosity 28–35 SSU

Discharge (Flange Dim.) 2½ in. (63.5 mm)

Recessed impeller provides steep non-overloading operating curve.

Oil-filled motor for max. heat dissipation and constant bearing lubrication.

Recessed impeller reduces radial bearing loads, increases bearing life.

High torque three phase motors for assured starting under heavy load.

Seal leak probe warns of leak condition, prevents costly motor damage.

On-winding temperature-sensitive sensor.

Shredding ring and impeller are replaceable without dismantling pump or motor.
WG75HH/100H/150H BROCHURE
DOWNLOAD BROCHURE
2-15 HP WG SERIES BROCHURE
DOWNLOAD BROCHURE

WGX75HH/100H/150H INSTALLATION AND SERVICE MANUAL
DOWNLOAD MANUAL

WG75HH-WG150H/WGX75HH-WGX150H PUMP/SLIDE-RAIL ASSEMBLY DIMENSIONS
DOWNLOAD DATA

TYPICAL SIMPLEX INSTALLATION DRAWING FOR 3 - 7½ HP GRINDER PUMP/LIFT-OUT CHECK VALVE RAIL ASSEMBLY
DOWNLOAD DRAWING (WITH DIRECT MOUNTED PANEL)DOWNLOAD DRAWING (WITH REMOTE MOUNTED PANEL)DOWNLOAD DRAWING (WITH DIRECT MOUNTED PANEL)

TYPICAL DUPLEX INSTALLATION DRAWING FOR 3 - 7½ HP GRINDER PUMP/SLIDE-RAIL
DOWNLOAD DRAWING

TECHNICAL SPECIFICATIONS FOR 3 - 7½ HP LIFT-OUT CHECK VALVE RAIL SYSTEM
DOWNLOAD SPECIFICATIONS (STANDARD)DOWNLOAD SPECIFICATIONS (EXPLOSION-PROOF)

TECHNICAL SPECIFICATIONS FOR 3 - 7½ HP LIFT-OUT SYSTEM
DOWNLOAD SPECIFICATIONS (STANDARD)DOWNLOAD SPECIFICATIONS (EXPLOSION-PROOF)

OWNER'S MANUAL: REGAL GRINDER PUMP INSTALLATION AND SERVICE
DOWNLOAD MANUAL