Main Content Starts Here

PL Series Corrosion-Resistant Convertible Deep Well Jet Pumps

  • Lightweight Rustproof Pump Body Is Made of Dura-Glas -- Fiberglass Reinforced Thermoplastic.  All Components In Contact With Water Are Resistant To the Corrosive and Abrasive Forces Found In The Most Aggressive Water Conditions
  • Multi-Port, Reinforced Polypropylene Diffuser Design Primes Faster and Handles More Air
  • Precision Molded Noryl® Impeller Gives Perfect Balance and Ultra Smoothness for Highest Performance and Efficiency
  • Performance-Proven, Built-In Regulator is Adjustable For Best Performance On All Deep Well Installations. 
  • Stainless Steel Shaft Seal Acts As Heat Sink To Provide Maximum Cooling of the Shaft Seal
  • Dustproof Canopy On Motor Completely Encloses Electrical Components and Provides Dust, Dirt and Insect Protection.  Ventilating Air Cannot Contaminate Vital Switching Components
  • Permanently Lubricated, Heavy Duty Ball Bearings Ensure Smooth, Quiet Operation
  • Easy Serviceability Due to the Easy-To-Remove Stainless Steel Clamp.  Piping Does Not Have To Be Disturbed.   Seals Can Be Replaced In Just A Few Minutes

 

PUMP BODY and SEAL PLATE:  Dura-Glas

IMPELLER:  Noryl®

NOZZLE:  Noryl®

VENTURI:  Noryl®

CLAMP:  Stainless Steel

SHAFT:  Stainless Steel

DIFFUSER:  Reinforced Polypropylene w/ Brass Wear Ring

JET PACKAGES:  Sold Separately

PRESSURE SWITCH PRE-SET:  30 - 50 PSI

PORT SIZES:  Suction: 1-1/4" / Drive: 1" / Discharge: 1"

SUCTION PORTS:  Suction-Over-Drive

:  . . . . . NORYL® is a registered trademark of SABIC INNOVATIVE PLASTICS IP B.V

Owner's Manual: PL Series
DOWNLOAD MANUAL
Instructions: Pressure Switch Adjustment
DOWNLOAD INSTRUCTIONS
Sell Sheet
DOWNLOAD SHEET
Accesories
PRESSURE GAUGES